Fuse | FS109

76 Pro Line

rateraterateraterate
(0)
No Reviews Yet
Packaging

50/1

Weight

3.00

Build a better fireworks show with Talon Igniters. Setup is super easy! Just clip the end directly onto the fuse as you would a clothes pin. Compatible with most firing systems.

Installation Tips:
- Do not remove the rubber band. When installing the clip onto the fuse, do not move the clip up, down, or side-to-side on the fuse. Movement after installation can cause damage to the heating element.

- Carefully Install the clip onto the fuse (as if it were a clothes pin going onto a line). The heating element will wrap around and hug the fuse.

- Once installed, tape the clip in place to secure it from movement. This helps protect the element from being damaged prior to operation of the device.

- It is recommended to only connect one safety igniter per cue on the firing system. This allows operator to verify continuity and assures maximum firing current is applied to the device.

- Always use parallel wiring when connecting more than one safety igniter per cue. Never connect safety igniters in series. Test your system to confirm their is enough voltage / amperage when connecting more than one safety igniter per cue. Length of wire will also be a determining factor as to how many safety igniters can be connected in parallel on a single cue.

 

facebook facebook Pintrest facebook

 
 
Spirit of 76

Related Products

Talon Igniters 1M (Box)
FS103  100/1
 42 in stock UPS
Talon Igniters 3M (Box)
FS106  80/1
 14 in stock UPS

Customer Comments

 

No Comments